1 year bareroot plant guarantee
Mail Order Plants to Your Door Year Round
5 Star Service Rating
Secure, One-Tap Checkout
5 Star Feefo Rating
Hand Picked, Delivered to Your Door!
1 Year Bareroot Guarantee
Platinum Trusted Service Award 2026
Mail Order Plant Experts - Est. 1949
Skip to content
visible

Saving a Tree that is Falling Over

16/10/2025

It crossed my mind this morning that we are in August. September is the other month of the equinox (exactly half a year away from Shakespeare's "Beware the Ides of March"). March and September are the months when the Earth tilts just more than halfway to or from the Sun.

So September and March are the months when gales are most likely and trees are most at risk of being blown over. Fruit trees are especially vulnerable, especially when laden in autumn.

I hope this does not happen to you, but if it does, here is how you can save a leaning tree (...and you might want to take preventative action on trees that are leaning now).

By the way, if the tree falls over, cut it up for firewood - it cannot be saved. These instructions only apply to trees that are LEANING:
1. You need to stabilize the tree (stop it from leaning more). The best way to do this is by propping it up. Anything long enough and strong enough will do. Your local friendly engineering workshop will make you up a Y shaped prop, or you can use a stout bit of timber (cut down floor or roof joist from a skip, 3"x3" fence post, something like that). An Acrow prop would be the best if you can get one - incredibly strong and capable of being made longer or shorter while in position.

Ideally, you want to give the prop a foundation, so it does not drive into the soil under the weight of the tree. Obviously a concrete footing is best, but a paving slab will do the job, even a large rock. The prop needs to be as close to right angles to the trunk of the tree as possible and held really tightly by the foundation. Concrete does this all by itself. For anything else jam the prop in by hitting its base towards the bottom of the tree so it slides across and then gets stuck on the foundation.

2. Ideally in winter (but if the tree is leaning badly do it now) completely cut out one of the large branches that is causing the tree to lean. This reduces the weight that is causing the tree to lean. You can do another the year after and so on. This winter or next spring, prune the side AWAY from where the tree is leaning and prune it hard.

Sounds mad, but it will cause new growth on the "good" side, which will help stop it falling over.

3. As a minimum, the tree should stabilise and more root will form away from the direction it is leaning, which will anchor it. If it is relatively small, you can gradually force it upright as the tree reshapes. Keep on pushing it up and in a few years it will be vertical.

But let's hope the winds don't blow.

Watch your plants grow, and Enjoy!

Comments (9)

Add a comment
  1. Kevin

    I have a large pecan tree (over 60’ tall). It has a visible lean to it, and you can see where the ground has lifted on one side from the roots pulling up. For a tree of this size is it worth trying to prop up? I’ve seen where they dig a large concrete block or two into the ‘good’ side of the tree and use wide straps to help start pulling the tree back. This concerns me that if the tree starts to go then the blocks may become projects like a catapult. What would you suggest or should we get someone to come onsite to make suggestions?

  2. Anne-Marie Pagett

    I have an overgrown escalonia which is now a tree and leaning badly in the wind. I want to keep it for privacy if possible but I do not have a friendly engineering workshop to make me the Y shaped sturdy prop I need. Can you suggest where I could buy one? None of the usual commercial outlets seem to have them. Many thanks Anne-Marie

  3. Mick Sidaway

    I have a medium size eucalyptus that we planted 3 years ago, close to a pergola. Unfortunately, the prevailing winds have forced it over and the ground seems to be developing a crack on the upwind side. It has two large boughs and a main trunk with good foliage. Is there a way to stop it moving any further?

  4. David Pike

    Hi, I have a very mature (main trunk diameter of 37cm) Victoria Plum tree which annually bears abundant fruit. The tree is leaning 40deg from the horizontal (50deg from vertical). I feel it is beyond recovery but I want to prevent any increased lean. What strategy/techique should I use? Is it valid to prop the main trunk with a sturdy rot-free trunk of a recently felled tree? What angle and where would be the most ideal placement be? Should I shape the supporting end to fit around the Plum tree trunk? Thank you.

Leave a comment

Please note, comments need to be approved before they are published.